Those that installed springs, did you cut your rubber bump stops?

[damage]

I saw this video where these guys cut a portion of their bump stops. Check here:

Sponsored

 

[Shankmeyster]

You had to on the 10th but I looked on the paper for my H&R springs and it says my Si springs don't require a cut. If you notice a lot of hard bouncing coming from the front then I'd pull them and cut. If you don't have install instructions with them then email or call the manufacturer. Hell it might even be on the website whether or not you have to cut the bumpstop.

 

[kmkiger]

I also purchased the H&R springs and did not have to cut the bump stops.

 

[Cousindeagle]

Eibach lowering springs installed. We cut out out one rib/20mm

 

[keonigt]

I also purchased the H&R springs and did not have to cut the bump stops.

I'm thinking of getting the H&R springs also. Have you noticed any bottoming out since you didn't cut the bump stops?

 

[kmkiger]

I'm thinking of getting the H&R springs also. Have you noticed any bottoming out since you didn't cut the bump stops?

No Issues at all. No complaints. No bottoming out. Still happy with the purchase.

Sponsored