Opinion on Varis ARISING-1 Evo Carbon+ GT Wing

[sugarl4nd]

Hey guys, just wanted to get your opinion on Varis ARISING-1 Evo Carbon+ GT Wing to replace OEM wing.

Some pictures for your pleasures ?

 

[TW00Si]

It looks good to me. It’s one of my wing options.

 

[Shingo Shoji]

This is nice. Definitely going to consider this along with the Spoon swan neck

 

[Zeke01]

Another option, Result Japan. I like how the curves flow with the body vs the straight wing.

 

[CTR]

When I clicked into this thread I thought I was going to hate it but I think it looks better with a more square wing on the rounded hatch. It looks more aggressive but works proportionally.

The low rear perspective of this car is the only angle I don't personally like in stock form.

 

[Bigfx]

Another option, Result Japan. I like how the curves flow with the body vs the straight wing.

That one is awesome

 

[TW00Si]

Another option, Result Japan. I like how the curves flow with the body vs the straight wing.

The middle looks good but the end/side plates looks weird.

 

[Shingo Shoji]

It’s hard to get any detail on the GT wing. Does anyone know if it uses the same holes to install?

 

[Shingo Shoji]

Couldn’t agree more. I think a square wing really finished off the FL5 well. I like the rear view but it does look a little too curved and this totally fixes it IMO

When I clicked into this thread I thought I was going to hate it but I think it looks better with a more square wing on the rounded hatch. It looks more aggressive but works proportionally.

The low rear perspective of this car is the only angle I don't personally like in stock form.

e

 

[sugarl4nd]

Thanks guys ... I pulled the trigger, just put the pre-order of the Varis wing. According to Bulletproof Automotive, it is utilizing the existing OEM holes - so, full bolt-on. Will let u know how it turn out

 

[TW00Si]

Thanks guys ... I pulled the trigger, just put the pre-order of the Varis wing. According to Bulletproof Automotive, it is utilizing the existing OEM holes - so, full bolt-on. Will let u know how it turn out

Nice. I thought it would be wider than the Spoon GT wing but it’s not. Not by much though. Can’t wait to see your installed pictures and review. I am on the fence with this wing.
How long is the estimated wait?

 

[sugarl4nd]

Nice. I thought it would be wider than the Spoon GT wing but it’s not. Not by much though. Can’t wait to see your installed pictures and review. I am on the fence with this wing.
How long is the estimated wait?

According to Bulletproof Automotive, estimated 6 months

 

[TW00Si]

According to Bulletproof Automotive, estimated 6 months

So you’ll be ready for winter. Then again you probably don’t get any/much snow where you are.

 

[sugarl4nd]

So you’ll be ready for winter. Then again you probably don’t get any/much snow where you are.

No snow in this side ... But plenty of sun

 

[02SilverSiHB]

Thanks guys ... I pulled the trigger, just put the pre-order of the Varis wing. According to Bulletproof Automotive, it is utilizing the existing OEM holes - so, full bolt-on. Will let u know how it turn out

good choice. I feel like it's the best wing compared to like APR, etc. This one isn't toooo wide, compared to the specs I read on APR.

Sponsored