4 point harness

[TW00Si]

Anyone can describe where the lap belts would go after using this part for the shoulder belts? https://www.mandm-honda.com/shop/products/detail.php?product_id=1456

I run a 6 points harness in my S2000 and have a rollbar and eyelets for the setup. Just not able to picture how this would work with a 4 point.

Sponsored

 

[HONDANB]

I assume to the stock mounting points. 2 on the back 2 stock mounting points total 4 point harness

 

[TW00Si]

So this looks like mounting points for the lap belt only.
Anyone know if it’s possible to use the children car seat latches in the back seat to secure the shoulder belts?

 

[HONDANB]

Judging by the pics, those adapters would be more like for the shoulder straps and the belt straps would use the stock mounting points.

 

[TW00Si]

Looking at Schroth install guide, the shoulder belt should be parallel or at most 20 degrees lower. So anchoring to the back of the driver seat shouldn’t be done.

I’m also trying to use my existing hans neck restraints but it looks like without a harness bar, it shouldn’t be used either. So the stock seat belt it is. Unless someone knowledgeable with safety restraints can chime in.

 

[mparra11]

Anyone make a harness bar yet?

Sponsored