Recent content by JDM_DOHC_SiR

  1. HKS Turbo for FL5

    Well here it is......... the MHI stage 2... err ummm i mean the HKS GT turbo in all it's glory....:p 99.9% it's an MHI stage 2 turbo
  2.

    Official SONIC GRAY PEARL FL5 Type R Photos Thread

    No rubbing issues at all. :thumbsup:

  3. FK8 vs FL5 interchangeable brake pads?

    Yes perfectly fine

  4. What did you do to your FL5 today?

    Added a few more goodies I had Carbon-fiber-six-element make for me wasn't a fan of the Spoon Plug cover I had on before the Yellow with the red cover wasn't doing it for me so I had them make me a cover just like it but with the Red OEM Kevlar vs the Yellow Kevlar like Spoon makes...

  5. Clutch options for high HP/TQ

    The Exedy Stage 1 Clutch Comb should hold what you can throw at it unless you are trying to bring in 400ftlbs around 3000rpm:p DRob has quite a bit of experience and I would trust his recommendation :thumbsup:

  6. What did you do to your FL5 today?

    100% OEM… didn’t realize how many clips were on these seats.. there had to have been over 105-115:doh: … I lost track Might need to DM you about one last time I have my Eye on that you did …:thumbsup:

  7. What did you do to your FL5 today?

    Decided to torture myself and do one of that last pieces I have been holding out on doing for over 2 years:confused1: So I put aside some time and did the rear Alcantara seat skin swap.. let me tell you those seat ring pliers to do this job make life very easy…. But it’s not an easy 1-2 and done...

  8. What did you do to your FL5 today?

    Squeaked in a few more goodies before the new year…:thumbsup: Hondata CanFlex System Infinity Design carbon intake/ Inlet pipe (Same serial number as my CTR 00795) SiriMoto Carbon Towerbar Spoon Red Valve Cover Spoon Carbon Plug Cover Ported Intake Manifold Ported High pressure fuel line...

  9. Where’s the Aero?

    Looks great!! How much was it to color match it?

  10. Tegiwa intake comparison/test

    The only code that currently works is the INFINITY15 code. :hmm:

  11. Frankenstein A/C vent trim update with Si Red Trim Ring

    The Drivers side vent is a snap out and swappable.. but the main grill needs to be cut and re attached... not easy to do... I would not do this again if I wanted too... very nerve racking doing this and if you mess it up you just blew a good chunk of change..?
  12.

    Jester’s FL5 build journal.

    Nice!! Which way did you route the wire harness to the inside.. through the grommet in the firewall or through driver side door weather strip?

  13. Jester’s Hondata thread

    Can’t wait to see what data you come up with and to see how much we will be limited to on the the fueling:thumbsup:

  14. 2023 FL5 Civic type R accessory installation

    I’ll see if I can get some info up here in the next couple of days:thumbsup: Won’t be back home until the end of the week and I have the info you need at home…

  15. FL5 Lowering Springs

    The H&R spring Rates are as follows if you needed them:coffee: Spring Rate Front: 4.5 kg/mm Spring Rate Rear: 5.1 kg/mm I went with H&R on my FL5 and didn't have reverse rake and the ride is very nice compared to stock :thumbsup:
See more




Top