Recent content by PangziXin

Your products are extremely hardcore and cool. To be honest, I more or less followed your approach. In mainland China, purchasing your excellent products is very expensive, so I used many used OEM parts from dismantled vehicles to complete the build. In the end, the results turned out quite...

flash back to stock and compare

换成hondata 够用了~

GM sensor oe：13577429，it works fine on 1.5T models

best record is about 9.6s when i use stock turbo and #98 fuel（winter）

my model only has initial support, this is my settings

about 23.5psi with 6~8 timing advance

I'm using a used part from an RDX. People who sell used parts usually aren't as careful with them as we are, so it's very likely that it has been dropped or pressed at some point. However, given the structure of a high-pressure fuel pump, metal fatigue is unlikely to occur. The hand in the photo...

Still in the break-in period, I encountered a sudden P0028 fault during slow city driving. I noticed the DIFP dropped to 0.4 bar—sure enough, the high-pressure fuel pump had failed. When I removed the old 6B2 pump, I was surprised to find it had actually broken, which is extremely rare. Since...

The thermostat is quite inexpensive. Although the one for the 11th-gen costs about twice as much as the one for the 10th-gen, it's still only around $30. Maybe I could send a few to fellow enthusiasts in the U.S. who need one.

I'm in China, and suppliers here can provide custom thermostats at any temperature setting. Most off-the-shelf products, like those from Spoon, are set to 68°C — just like the one I'm currently using. I believe they're not suitable for street use, as the coolant temperature often stays below 80°C

Temp issue update： After testing, the coolant temperature issue was caused by the thermostat. I replaced it with a 68°C thermostat, and the water temperature now stays steadily at around 80°C. However, during ground cruising, the temperature often drops below 80°C, so I think I will replace it...

Let me give you a progress update. In the end, I used a brand-new 59B engine block, which includes additional water jacket support. Inside the block, I used a 10th-gen Civic crankshaft, forged connecting rods, forged pistons, and oil squirters. You will need to continue using the 11th-gen timing...

Exciting update! I took a close look at the short block link on the TSP website and have some questions. It looks like the deck surface has been machined quite a bit—the coolant passages between the cylinders are almost flattened. Why did TSP choose to do this? Additionally, with the deck...

Let me update you on my progress. First, I'm mimicking the setup of American car enthusiasts, similar to DIY projects and Axion/FK8TD kits from forums. I purchased the fuel injectors and high-pressure fuel pump from the Acura RDX 2.0T, both with the part number 6B2. I believe I can use the...